Arlington (Main Office)
Boost Air And PlumbingArlington, TX
- 2313 Michigan Ct
Arlington, TX 76016 - (817) 839-4672
- Mon–Fri: 8:00 AM – 6:00 PMSaturday: 9:00 AM – 6:00 PMSunday: Closed

Arlington, TX
Local shop at 2313 Michigan Ct — dispatched trucks, honest diagnostics, and same-day service across Arlington and the DFW Metroplex.
No spam. We'll text or call within business hours.
Or call (817) 839-4672 — same-day dispatch most weekdays.
Arlington response time
Most weekday calls get a tech on site within 2–4 hours.
Neighborhoods covered
North & south Arlington, Viridian, Dalworthington Gardens, Pantego, Lake Arlington — plus the wider Metroplex.
Licensed for Texas
TDLR HVAC + TSBPE master plumber. Permits pulled in-house.
Boost Air And Plumbing — Arlington, TX
2313 Michigan Ct, Arlington, TX 76016
Boost Air And Plumbing — Grand Prairie, TX
Grand Prairie shop — serving all of GP
What neighbors say
All nine service categories run out of the same Arlington shop. From a quick HVAC tune up to a full sewer line replacement, one phone call covers it.
Replacing an AC system in Arlington usually means dealing with an undersized return, a leaky plenum, and a 20-year-old line set that someone wants to keep. We do Manual J load calcs before quoting, so the new condenser is actually sized for your house — not just matched to the old one. We install Trane, Carrier, Goodman, and Lennox. Every install gets a new pad, a new filter drier, a fresh nitrogen pressure test, and a deep vacuum before the refrigerant goes in.
Learn moreMost Arlington no-cool calls trace back to a failed run capacitor, a tripped float switch on a clogged condensate line, or a contactor that won't pull in. We carry the common parts on the truck, so the average repair gets done on the first visit. If the compressor is locked or the evaporator coil is leaking, we'll lay out the repair-vs-replace numbers honestly — no scare tactics about Freon shortages or imaginary code violations.
Learn moreArlington homes built before 2010 often have flex duct that's collapsed in the attic, full of construction dust, or disconnected at a register boot. We pull and inspect the runs, vacuum the trunk lines with proper negative-pressure equipment, and seal up leaky joints with mastic — not just tape. Real duct cleaning is a half-day job done right, not a 30-minute vacuum-and-leave.
Learn moreArlington furnaces sit dormant most of the year, then get asked to run flat-out the first night the temperature drops. That's when ignitors crack, flame sensors crud over, and pressure switches stick open. We test combustion with an analyzer, check static pressure on the blower, and inspect the heat exchanger for cracks before sending you back into the cold.
Learn moreWe install gas furnaces, heat pumps, and dual-fuel systems sized for Arlington's mild winter and brutal summer. A heat pump makes a lot of sense here — it does the cooling work eight months a year and handles heating down to about 35 degrees, with the gas furnace kicking in below that. We pull the gas permit, do the venting calcs, and set the manifold pressure correctly on every install.
Learn moreAs a full-service HVAC contractor, we cover everything between the thermostat on the wall and the condenser in the side yard. That includes seasonal tune-ups, indoor air quality additions like UV lights and media filters, and the static-pressure work that actually fixes the rooms in your Arlington house that never quite cool down.
Learn moreOn the commercial side, we handle rooftop units, exhaust fans, makeup air, and the gas piping that ties them together. We work on small commercial buildings around Arlington — restaurants on Cooper, retail off I-20, and light industrial near the Great Southwest Industrial District. EPA 608 universal certification, fully insured, and we coordinate with general contractors on tenant finish-outs.
Learn moreArlington's clay soil punishes sewer lines. We run cameras to find the actual problem — bellies, root intrusion, offset joints, or a collapsed section — instead of just snaking it and hoping. For surface drainage, we install French drains and catch basins to move stormwater away from foundations on lots that always pond after a hard rain.
Learn moreFrom slab leak detection to tankless water heater installation to repiping a pre-1990 copper system, our plumbing crew handles the full range of Arlington residential work. Flat-rate pricing, TSBPE master plumber on every crew, and a 24/7 emergency line for after-hours blowouts. Permits and inspections handled in-house.
Learn moreOur shop sits at 2313 Michigan Ct, just off Pioneer Parkway between Bowen Road and Cooper Street. Arlington is home base — when you call, the truck is rolling from inside the city, not from a dispatch center two counties over.
That matters during a July heat wave, when an AC failure on a 105-degree afternoon needs a same-day fix. It also matters at 11pm on a Sunday when a supply line lets go under a kitchen sink. Most weekday Arlington calls get a tech on site within a few hours of the phone ringing.
We've been working on Arlington homes for over a decade — from the older brick ranches near UTA and Lake Arlington to the newer builds in Viridian and the master-planned sections off I-20 near Mansfield. We know which subdivisions still have 1980s copper, which ones got cheap builder-grade R-22 condensers in the early 2000s, and which neighborhoods sit on the worst expansive clay in Tarrant County.
Our techs are NATE-certified on the HVAC side and TSBPE-licensed on the plumbing side. That dual licensing means one phone call solves both problems when a leaking water heater is also taking out the furnace it sits next to in the closet.
Arlington's climate is brutal on mechanical equipment. Summer attic temperatures regularly clear 140 degrees, which cooks the lubricant out of blower motors and bakes the insulation off refrigerant lines. Winter brings the occasional hard freeze that catches uninsulated hose bibs and exposed pipes off guard — the 2021 freeze taught everyone in town that Texas plumbing is not actually built for sub-20 weather.
The soil under most of the city is the same sticky black clay you find across the DFW Metroplex. It swells in spring rain, shrinks in August drought, and pulls cast-iron drain lines apart at the joints. We see slab leaks every week — usually in homes 25 to 40 years old where the original copper has finally given up at a fitting under the foundation.
Water quality is another factor. Arlington Water Utilities pulls from Lake Arlington and Cedar Creek Reservoir, and the finished water runs hard enough to scale a tankless water heater inside of three years if it's never flushed. We see plenty of dead heat exchangers, crusted-over shower valves, and short-lived dishwashers that all trace back to untreated hard water.
The good news: every one of these problems is fixable, and most are preventable with the right maintenance schedule. We do honest diagnostics, flat-rate quotes, and we'll tell you when a repair makes more sense than a replacement.
Calls get a real human on the phone, not a five-minute phone tree. We ask enough questions to send the right truck — a no-cool call gets a tech with a vacuum pump and refrigerant on board, a sewer backup gets a tech with a camera and a jetter on the trailer.
On site, we diagnose first and quote second. You'll see a flat-rate price before any tools come out. If we find a second issue mid-job, we stop and show you before charging anything new. No surprise invoices.
For bigger projects — a full system replacement, a repipe, a sewer line replacement — we walk the house with you, take photos, and email a written quote with line items. Permits get pulled when code requires them. Inspections get scheduled and we meet the inspector ourselves.
For permit lookups, code requirements, and utility info, the City of Arlington official website is the authoritative source — we pull permits through their portal on every job that requires one.
0% APR financing available on qualifying installs
Ask about our current promotions when you call — approved homeowners can spread the cost interest-free.
Arlington FAQs
We dispatch from 2313 Michigan Ct, so most Arlington calls get a truck the same day. Call (817) 839-4672.
ServingArlington HVACandGrand Prairie HVACwith same-day dispatch.
Visit our shops
Boost Air And Plumbing dispatches trucks from our Arlington main office and our Grand Prairie shop, covering Tarrant and Dallas counties with same-day HVAC and plumbing service. Call (817) 839-4672 for either location.
Arlington (Main Office)
Grand Prairie