Arlington (Main Office)
Boost Air And PlumbingArlington, TX
- 2313 Michigan Ct
Arlington, TX 76016 - (817) 612-9107
- Monday to Saturday: 8:00 AM to 7:00 PM

Boost Air Blog
AC Leaking Water Inside in Grand Prairie? Call (817) 612-9107 or Book Online
Part of our AC Repair guide.
Quick answer
An AC leaking water inside a Grand Prairie house is usually condensate that could not leave the attic: a clogged drain, a cracked or rusted pan, a frozen coil that thawed, or a pump that quit. Many air handlers sit over the ceiling on a slab. Shut the system off if water is coming through. In winter, a high-efficiency furnace can leak condensate from the same attic.
An air conditioner leaking water inside in Grand Prairie is usually not a mystery leak from the outdoor unit. The outdoor unit dumps heat. The water is made indoors, on the evaporator coil, and it is supposed to leave through a drain. When that path clogs, cracks, or freezes, the water goes to the ceiling. Grand Prairie has a lot of slab-on-grade houses. The air handler and the coil sit in the attic or a closet, directly over rooms. A pan that overflows does not have a basement to fall into. It has drywall.
This page splits the causes: a clogged condensate line, a bad pan, a frozen coil, a failed pump, and the winter version, when a high-efficiency furnace makes water in the same attic. The common repair list, including attic drains, is AC repair in Grand Prairie. Fall and winter problems worth fixing before the next summer, written for a neighboring city, are in AC repair in Arlington. AC repair is the service. HVAC service in Grand Prairie is the local page.
Shut the system off if water is coming through a ceiling or onto a floor. Running it to see whether the pan dries out adds more water. If water has reached wiring, the furnace switch, or a light fixture, leave the breaker off. Do not stand on a wet attic joist to bail a pan.
If you smell gas, leave. Many air handlers sit on a gas furnace. Do not flip switches or use a phone inside. Call your gas utility or 911 from outside. If a carbon monoxide alarm sounds, get everyone out and call 911. Do not treat a gas smell as a drain problem.
Cooling pulls humidity out of the air. That water collects in a pan under the coil and should run out a PVC line, usually to a spot outside near the condenser or along the foundation. Algae grows in that line. North Texas runs the air conditioner for months, so the slime has all summer to close the pipe.
When the line clogs, the pan fills. A float switch, if it works, opens and shuts the outdoor unit off. The blower may keep running, so the house gets warm air and you may not see water yet. If the float fails, or there is no float, the pan overflows. The first sign is often a stain or a drip in the ceiling under the attic unit, not a puddle at the outdoor pipe.
A cap of slime you can see at the outdoor end of the line is reasonable to clear, with the system off. A wet vacuum on that end sometimes pulls a plug through, if you are only working at the termination you can reach from the ground. If nothing changes, or the water is already in the attic, stop. Do not pour bleach, vinegar, or hot water into a line you cannot see the other end of. Do not disconnect PVC in the attic and let it drain onto the insulation.
The repair is the clog, and a float and a pan that still hold water. A safety that already let the ceiling get wet needs to be part of the visit, not another reset.
The primary pan is under the coil. A secondary pan, or an emergency pan, sits under the whole air handler in many attic installs so a leak has one more chance to be caught. Both can fail. Plastic pans crack. Metal pans rust through, especially after years of standing water from a slow clog. A pan with a hole does not need a clogged line. The water leaves through the hole, into the attic, and then through the ceiling.
A secondary pan with a drain of its own, or a float, exists so this does not become drywall work. If that pan is full, the primary drain has already been losing. Shut the system off. Do not drill or punch a hole to "let it out" into the insulation. That trades a contained pan for a wet attic. Do not tape a crack and turn the system back on. The tape will not hold condensate for the rest of the summer.
A pan that has rusted through is a parts repair. The price depends on the air handler, whether the coil has to be lifted, and how much of the ceiling is already wet. There is no single Grand Prairie leak price. You should hear what failed, and the price, before parts go in.
A coil that ices over is not making a normal condensate stream. Airflow is too low, or the refrigerant circuit is not right, so the coil drops below freezing. The filter, a dirty coil, closed supplies, or a blower that is weak are the airflow side. Low refrigerant from a leak is the charge side. While it is frozen you may see little water. When it thaws, a lot of water leaves at once, faster than a partly clogged drain can take, and the pan overflows.
If the large copper line at the air handler is a block of ice, or the coil is iced when you can see it without taking panels apart, turn the system off and let it thaw. Do not chip ice and do not pour hot water on the fins. Put towels under a ceiling drip if you can do that from the room. The thaw is the water you are seeing. The cause is still there. A new filter is the homeowner step if the filter is packed. If a clean filter and open vents do not stop the next freeze, call. Do not add refrigerant from a can. Low charge means it left the system, and a top-off is not a leak repair.
Ice on the outdoor unit in summer, with the fan not spinning, is a different fault (often the condenser fan or the capacitor) that can also end in a frozen indoor coil. Leave the disconnect off if the outdoor unit hummed and the fan sat still. Do not open that electrical compartment.
Some systems cannot drain by gravity. A small pump lifts the water. When the pump fails, the reservoir fills, a safety should stop the system, and if that switch fails the water overflows in the closet or the attic. Silence plus a full reservoir means turn it off and call. Do not bypass the safety so the system will run.
Homeowners call a January drip an air conditioner leak because the stain is in the same place as the August stain. A straight cooling coil should be dry in winter if the thermostat is on Heat. A high-efficiency furnace is different. It makes condensate when the burners run. That water goes through a trap and a drain, sometimes a pump, and it can use the same attic path the air conditioner uses.
A clogged furnace trap, a frozen or sagging line, or a pump that quit will shut the burners off on a float, or it will overflow the pan on a cold night. North Texas does not stay below freezing for long, but a hard front is enough to ice a trap that sat all fall, or to show a drain that was already marginal. If the ceiling drip shows up only when the heat is on, say that when you call. It changes which appliance gets tested first.
The response is the same while you wait: heat off if water is actively dripping, breaker off if water is on wiring, and no one in the attic bailing a live furnace. If you smell gas or exhaust while this is happening, leave and call from outside.
On an AC repair call for water inside, the technician finds where the water is leaving the normal path: drain, pan, coil, pump, and, in winter, the furnace condensate. A frozen coil gets an airflow check before anyone talks about refrigerant. You hear what failed, and the price, before parts go in.
A clog, a pan, a pump, or a float on a younger system is usually a repair. A coil that will not hold refrigerant, or a major failure on equipment around 15 years old, is a time to hear a replacement price next to the repair. Industry guidance, including Department of Energy Energy Saver material, puts a typical central air conditioner life around 15 to 20 years. That is a prompt, not an expiration date. The install, the drain, and the charge decide more than the badge on the cabinet.
Boost Air HVAC & Plumbing repairs air conditioners and furnace condensate leaks in Grand Prairie, Arlington, Mansfield, Fort Worth, and nearby communities. See our AC repair service and HVAC service in Grand Prairie. Call (817) 612-9107 or book online. $0 service fee with approved repair. Same-day service Mon-Fri. Hours are Monday through Saturday, 8am to 7pm.
Why is my Grand Prairie AC leaking water inside the house? The usual causes are a clogged condensate drain, a cracked or rusted drain pan, a frozen evaporator coil that thaws and overflows, or a condensate pump that quit. On a slab house the air handler is often in the attic, so the water shows up on a ceiling. Shut the system off if water is above a room.
Can I clear the clog myself? A cap of slime at the outdoor end of the PVC line is reasonable to clear with the system off. If the clog is in the attic, the pan is full, or water has reached wiring, leave it. Do not punch a hole in the pan to let it drain into the attic, and do not pour bleach through a line you cannot see.
Why would the air conditioner leak in winter? A straight air conditioner should not be making cooling condensate in winter. A high-efficiency furnace does make water when it heats. That condensate uses a trap and often the same style of drain. A clogged furnace drain or a failed pump can leak in the attic on a cold night and look like an air conditioner leak.
Is water from the vent a refrigerant leak? Water at a ceiling or a vent is almost always condensate, or melt from a frozen coil. Refrigerant does not pour out as a puddle of water. Ice on the copper lines or the outdoor unit, plus weak cooling, can mean a charge problem. That diagnosis belongs with a technician. Do not add refrigerant from a can.
What if water reached the ceiling and the furnace switch? Shut the system off at the breaker if you can do that without standing in water. Do not run it to "see if the pan dries." If you smell gas, leave and call your gas utility or 911 from outside. If a carbon monoxide alarm sounds, get everyone out and call 911.
Call (817) 612-9107 or book online. We serve Arlington, Grand Prairie, and the surrounding North Texas communities.
Visit our shops
Boost Air And Plumbing dispatches trucks from our Arlington main office and our Grand Prairie shop, covering Tarrant and Dallas counties with same-day HVAC and plumbing service. Call (817) 612-9107 for either location.
Arlington (Main Office)
Grand Prairie