Limited-time financing: 0% APR for 24 months on new HVAC system installs.Claim now
Boost Air And Plumbing logo, HVAC and plumbing in Arlington, TXBoost Air And Plumbing
Boost Air And Plumbing service van ready for a same-day call

Boost Air Blog

Heat Pump Blowing Cold Air in Arlington, TX: Defrost, Aux Heat, and a Real Fault

Heat Pump Blowing Cold Air in Arlington? Call (817) 612-9107 or Book Online

Part of our Heat Pump Repair and Installation guide.

Quick answer

A heat pump blowing cold air in Arlington is often a few minutes of defrost, or ducts full of attic air, and then the supply air warms. Air that stays cold, an outdoor unit that never starts, or a coil that is a solid block of ice is a real fault. Emergency heat locks the compressor out and runs the electric strips. If the outdoor disconnect smells hot, leave it off.

A heat pump blowing cold air in Arlington is a specific feeling at the register. The thermostat says Heat. Air is moving. It feels cool on your hand, or it felt cool for a few minutes and then warmed, or it has stayed cold since the front came through. Arlington winters are mostly mild, then a night in the 30s asks a heat pump that spent the summer cooling to reverse. Defrost, auxiliary heat, and emergency heat are three different things. Homeowners mix them up because the air at the vent feels the same for a few minutes.

This page separates a normal cool burst from a heat pump that is not heating. The same complaint on a central heat pump in a neighboring city is heat pump not heating in Grand Prairie. A ductless head that will not heat is mini split not heating in Arlington. If the outdoor unit is finished and you are pricing a replacement, national ranges are in heat pump replacement cost in Arlington.

Electrical problems are a stop. Reset a tripped breaker or the outdoor disconnect once. If it trips again, the disconnect smells hot, or you see scorched wire, leave it off. Do not open the outdoor electrical compartment. Do not add refrigerant from a can.

If the house also has a gas furnace (dual fuel) and you smell gas, stop. Leave the home and call your gas utility or 911 from outside. Do not use a phone inside. If a carbon monoxide alarm sounds, get everyone out and call 911. A heat pump does not make carbon monoxide. A gas furnace in the same closet can.

What the air at the vent is telling you

Give the system about ten minutes on a steady call for heat before you decide it has failed.

A few minutes of cool air, then it warms. The ducts were full of room air, and in many Arlington houses those ducts run through the attic. The first air out of the register is whatever was sitting in the duct. Defrost does this too. The outdoor coil frosts in damp cold. The system briefly reverses to melt that frost. The indoor fan may keep running, and the vents feel cool until defrost ends. Steam off the outdoor unit on a cold morning is often that cycle. If the air warms when defrost finishes, the heat pump did what it is built to do.

Air that feels cool and the room is still warming. Heat pump supply air is milder than gas-furnace air. It can feel cool on your hand while the room temperature is rising. Measure the room, not just the draft on your wrist.

Air that stays cold. Air that is the same temperature as the room, or colder, after a steady call for heat is a fault. An outdoor unit that never starts, while the indoor blower runs, is a fault. A coil that is a solid block of ice, not a light frost that clears, is a fault.

The thermostat is not actually asking for heat. Cool, Off, or a fan set to ON moves air and does not run the compressor in heat. Emergency heat, covered below, can also be the reason the outdoor unit is silent while warm or lukewarm air eventually shows up from strips, or why the power bill jumped on a mild week.

Auxiliary heat and emergency heat

These are not the same switch, and the labels on the thermostat do not help.

Auxiliary heat, or aux, is the backup heat helping the heat pump. On a colder night the electric strips (or a gas furnace, on a dual-fuel system) can come on with the compressor so the house does not fall behind. You may see "aux" or "auxiliary" on the thermostat for a while during a cold start or during defrost. That can be normal. It should not stay on all day when it is 55 degrees outside.

Emergency heat locks the heat pump out and runs only the backup heat. The outdoor unit stays off on purpose. The electric strips heat the house by themselves, which costs more to run and is slower. Use emergency heat only as a temporary way to get heat if the outdoor unit has failed and you already know that setting. If you flipped it because the air felt cool during the first ten minutes, switch back to Heat and wait out a normal cycle. Leaving emergency heat on through a mild Arlington week runs the strips the entire time.

Do not keep flipping between Heat and Emergency to force a result. Each change can start another defrost or a lockout timer, and it makes the diagnosis harder. If you do not know why the air is cold, leave the thermostat on Heat, fan AUTO, setpoint a few degrees above the room, and call.

Ice, filters, and what not to do

Light frost on the outdoor coil that clears after defrost is normal in damp cold. A solid block of ice is not. Do not chip it, hit it with a broom, or pour hot water through the fins. You will bend the fins and you can puncture the coil. Shut the system off and call.

A packed filter can freeze the indoor coil and keep the heat pump from moving enough air. If you cannot see light through the filter, replace it with the size on the frame and latch the blower door. Do not run the system with the filter out. Leaves in the outdoor coil do the same job from the outside. Clear them without leaning on the fins.

Some heat pumps lose capacity in a hard freeze. A night in the 30s in Arlington should still produce heat from a working system, with aux heat if the outdoor unit needs help. Air that stays cold on a mild night is a fault, not a weather report.

A ductless system in a garage or a single room is a different machine, with the filter in the indoor head. Installation scope and national cost bands for that equipment are in mini split installation cost in Grand Prairie and a mini split for a garage in Southlake.

When it needs a technician

Call for heat pump service if the mode and the filter are right and the air still stays cold, the outdoor unit never starts, the coil is a block of ice, emergency heat is the only way the house warms, the breaker trips again, or the thermostat shows a code you cannot clear.

The technician confirms the thermostat is set up as a heat pump, that the outdoor fan and the compressor both run in heat, that defrost clears the coil, and that the reversing valve is not stuck in cooling. They check whether the strips or the dual-fuel furnace actually come on, and they check airflow before they talk about refrigerant. Charge, if the pressures say it is part of the fault, is measured after airflow is right. A top-off from a can does not find a leak.

A capacitor, a defrost board or sensor, a contactor, or a reversing valve on a younger system with a sound compressor is often a repair. A failed compressor, a coil that will not hold refrigerant, or a major failure on a system around 15 years old is a replacement conversation. A Department of Energy fact sheet lists an air-source heat pump lifetime of about 15 years. That is a prompt, not an expiration date. The badge is a weak predictor. Charge, airflow, sizing, and the ducts decide how long the next one lasts. HVAC service in Arlington is the local page.

Getting heat from the registers again

Boost Air HVAC & Plumbing repairs and replaces heat pumps in Arlington, Grand Prairie, Mansfield, Fort Worth, and nearby communities. See our heat pump repair and installation service and HVAC service in Arlington. Call (817) 612-9107 or book online. Hours are Monday through Saturday, 8am to 7pm.

Frequently asked questions

Why is my heat pump blowing cold air in Arlington?
A few minutes of cooler air can be leftover air in the ducts or a defrost cycle. Air that stays cold can be a thermostat still on Cool, a fan left on ON, an outdoor unit that never starts, a coil iced into a block, or a reversing valve stuck in cooling. Auxiliary heat and emergency heat are different settings. Emergency heat locks the heat pump out.
Is defrost the same as a broken heat pump?
No. In damp cold the outdoor coil frosts, and the system briefly reverses to melt that frost. The vents can feel cool, and you may see steam at the outdoor unit, until defrost ends. If the air warms when defrost finishes, the heat pump did what it is built to do. Air that stays cold after a steady call for heat is a fault.
Should I switch to emergency heat?
Emergency heat turns on the electric strips and locks out the compressor. Use it only as a temporary way to get heat if the outdoor unit has failed and you already know that setting. Leaving it on through a mild Arlington week runs the strips the whole time. Auxiliary heat is the strips helping the heat pump. It is not the same switch. If you do not know why the air is cold, leave the thermostat on Heat and call.
Can I chip the ice off the outdoor unit or add refrigerant?
No. Do not chip ice, hit the coil, or pour hot water through the fins. Fins bend and a punctured coil leaks refrigerant. Do not add refrigerant from a can. If the outdoor unit is a solid block of ice, switch the system off and call. Light frost that clears after defrost can be normal.
When does cold air mean the heat pump should be replaced?
A capacitor, a defrost sensor, or a contactor on a younger system is often a repair. A failed compressor, a coil that will not hold refrigerant, or a major failure on a system around 15 years old is a replacement conversation. National cost ranges are industry figures, not an Arlington quote. Your price depends on the system and the home.

Need a hand from a licensed tech?

Call (817) 612-9107 or book online. We serve Arlington, Grand Prairie, and the surrounding North Texas communities.

Visit our shops

Two DFW locations serving the entire Metroplex

Boost Air And Plumbing dispatches trucks from our Arlington main office and our Grand Prairie shop, covering Tarrant and Dallas counties with same-day HVAC and plumbing service. Call (817) 612-9107 for either location.

Arlington (Main Office)

Boost Air And PlumbingArlington, TX

  • 2313 Michigan Ct
    Arlington, TX 76016
  • (817) 612-9107
  • Monday to Saturday: 8:00 AM to 7:00 PM
Get directions

Grand Prairie

Boost Air And PlumbingGrand Prairie, TX

  • 2100 TX-360 Ste 907
    Grand Prairie, TX 75050
  • (817) 612-9107
  • Monday to Saturday: 8:00 AM to 7:00 PM
Get directions